-
34
-
5 - SETTING ONE OF FOUR RINGTONES
This program is used to set one of four ringtones for each apartment individually.
Enter the apartment number (if changes are to be made for all apartments at the same time, select
"0") and confirm with the "
key
" button. Then, enter a digit between 1 and 4 defining the number of
the ringtone - if setting for individual apartment, the selected ringtone will be activated for a moment
after each entry - confirm the selected ringtone with the "
key
" button. From this point on, the pre-set
ringtone will be heard in the apartment. The ringtone is set separately for each panel, so different
ringtones can be set in different panels; this way the resident is able to identify the panel transmitting
the call.
After restoring the factory settings of the panel, the ringtone 3 will be selected for all apartments.
6 - TEST ACTIVATION OF THE E-LOCK AND CALLING THE RECEIVER FROM APARTMENT
The function of test activation of the E-lock is useful during its adjustment or installation.
Activate it by entering "0". When the function is active, each time the "
key
" button is pressed, the E-
lock is activated (for the pre-set time). Use the "
#
" button to turn the function off.
The option of service calling of the receiver from apartment is activated during system
installation in order to enable the installer’s self-check if the receiver work OK (ringing, broadcast
channel and opening) directly from the apartment. With the receiver's handset lifted, press the door
opening button three times (for passive receivers) or press the door opening button once (for active
receivers). The panel will confirm receipt of this information with a triple beep in the handset (wait a
moment for it). When the signal is heard, hang up the phone. After a short while, the panel will
automatically ring this receiver.
Note!
This function is not available for loudspeaker receivers!
The function of service calling of a receiver from apartment can be activated by entering the number
of the receiver to be verified and confirming it with the "
key
" button. When this function is active, the
button illumination flashes and the system can be used as usually. The function is active for about
30 minutes. The function can be deactivated by running program 0 - service opening of E-lock.
7 -
CHANGING THE INSTALLER’S PASSWORD
This program can be used to enter 4 digits of the new installer’s password.
If the new password is to include numbers, for example, 5432, then enter these digits one by one.
Upon entering the last digit, the new password will be stored in memory.
NOTE!
Installer’s password cannot be restored!!! Setting the password to 0000 requires restoring factory
settings, which will lead to loosing all previously changed settings.
If restoring memory settings via a PC is also disabled, it will be impossible to unlock the
panel. Then only the manufacturer may restore the default installer’s password after returning
the device to Aco service (proof of purchase of the device or confirmation of the right to
configure the device is required).