-
33
-
Note that when using the
Code Table
, (which can be generated from
or
which is supplied for versions with numeric keypad only), the access codes correspond to physical
addresses set in the receiver, which is important when offsets are pre-set. When factory settings
are restored, so are the codes, to the pre-set code table. To lock the access codes completely, set
the "9999” code table.
Modification of administrator’s initial access code
Enter 0 as apartment number, confirm with the "key" button, and then enter the six digits of the new
code in sequence. Upon entering the last digit, the code
will be stored in unit’s memory as
administrator’s code. The new will erase the previous code value. The code is also erased when the
panel is reset to factory default settings. Do not enter a code starting with 1507, as these are the
initial digits of the installer's password (the panel will exit the programming mode).
Opening with the administration’s code is called by selecting the "key" button and entering the six
digits of the administrator’s code (or only the first four digits - after changing the panel configuration
via a PC). The second administrator’s code can only be set via a PC.
The administrator’s code is not pre-set.
2 - SETTING E-LOCK OPENING TIME
This program can be used to change the opening time, that is the E-lock operating time, from
1s to 10s by entering a digit between 0 and 9 (0 means 10 seconds). When the panel is reset to
factory settings, the time is set to 4s.
3 - SETTING THE NUMBER OF RINGTONES, PERMISSION TO CALL APARTMENT
This program can be used to change the number of ringtones from 1 to 7 for selected
apartments. Entering “0” as the number of ringtones makes calling selected apartment impossible.
Enter the number of the apartment (if changes are to be made for all apartments at the same time,
select "0") and confirm with the "
key
" button. Then enter the number of ringtones. A maximum of 7
ringtones for ringing can be set. The selected setting is stored in memory.
The receiver in the apartment with disabled ringtones will still support door opening with an access
code and will emit the door opening signal (use program 4 to disable it).
NOTE!
- When changing the number of ringtones simultaneously for all apartments, ringtones to
the previously deactivated apartments will be reactivated.
4 - TURNING ON - OFF THE DOOR OPENING SIGNAL IN THE APARTMENT
When the door is opened with the resident's access code or ACC proximity key fob, a short
beep is heard in the resident's apartment (door opening signal). This program is used to disable or
enable this signal in selected apartments. By default it is switched on. Enter the apartment number
(if changes are to be made for all apartments at the same time, select "0") and confirm with the
"
key
" button. Then enter digit "1" to activate the door opening signal or digit "0" to deactivate it. The
selected setting is stored in memory.