14A
5.
Check if the DMX cables run near or run alongside to high voltage cables that may cause
damage or interference to DMX interface circuit.
C.
Some fixtures don’t respond to the easy controller
1.
You may have a break in the DMX cabling. Check the LED for the response of the master/ slave
mode signal.
2.
Wrong DMX address in the fixture. Set the proper address.
D.
No response to the sound
1.
Make sure the fixture does not receive DMX signal.
2.
Check microphone to see if it is good by tapping the microphone.
E.
One of the channels is not working well
1.
The stepper motor might be damaged or the cable connected to the PCB is broken.
2.
The motor’s drive IC on the PCB might be out of condition.
9. Cleaning And Maintenance
The cleaning of internal must be carried out periodically to optimize light output. Cleaning
frequency depends on the environment in which the fixture operates: damp, smoky or particularly
dirty surrounding can cause greater accumulation of dirt on the fixture’s optics.
Clean with soft cloth using normal glass cleaning fluid.
Always dry the parts carefully.
Clean the external optics at least every 20 days. Clean the internal optics at least every 30/60
days.