REED A40HP Quick User Guide
pg 1
Turn on the Key Switch.
Pull out the Emergency Stop (E-Stop) Switch.
Push and hold the Start Button to start the
engine.
Turn on the Horn Switch to deactivate the
E-Stop Light. If the E-Stop Light is
ON
, the
pump will not operate.
Ensure that the Forward/Reverse Switch is at
FWD.
Start pumping by turning on the Pump
Switch. The S-Tube will start turning.
1.
2.
3.
4.
5.
6.
Starting the Pump
Turn off the Pump Switch.
Turn the Forward/Reverse Switch to REV.
Turn on the Pump Switch to start reversing
and removing the pressure.
Continue reversing until the Drive Cylinder
Pressure Gauge reaches 0 before
dismantling.
DO NOT
open the outlet & pipes
if there’s any pressure shown in pressure
gauge.
1.
2.
3.
4.
Pumping in Reverse
Control Panel:
1. Hour Meter
2. Emergency Stop (E-Stop) Button
3. Start Button
4. Key Switch
5. Remote/Local Control Mode Switch
6. High/Low RPM Switch
7. Horn Switch
8. Pump Switch
9. Forward/Reverse Switch
10. Stroke Change Switch
2
3
4
5
7
9
1
6
8
10
When the E-Stop Light is on, the
pump will not operate
