1
．
Display:
To show the various menus and the selected functions.
2
．
Dimmer Adjust Knob
：
Adjust the lightness for the unit
；
3
．
LED:
MASTER
On
Master Mode
SLAVE
On
Slave Mode
DMX
On
DMX input present
4
．
MAINS OUT:
PowerCon loop connection for main power supply to the next unit;
5
．
MAINS IN:
PowerCon connection from main power supply;
6
．
DMX IN:
For DMX512 link, use 5-pin XLR cable to link the unit and the DMX controlle
r;
7
．
DMX IN:
For DMX512 link, use 3-pin XLR cable to link the unit and the DMX controlle
r
；
8
．
DMX OUT:
For DMX512 link, use 5-pin XLR cable to link the next unit and output DMX signal;
9
．
DMX OUT:
For DMX512 link, use 3-pin XLR cable to link the next unit and output DMX signal;
10
.
RJ 45 Socket:
No function at the moment. Reserve for Art-net in the future.
11. Fuse (T 5A):
To protect the unit from damage of over current;
12. POWER SWITCH:
Turns On/off the power;
13. Button:
MENU
To select the programming functions
DOWN
To go backward in the selected functions
UP
To go forward in the selected functions
ENTER
To confirm the selected functions
6. Main Function
To select any functions, press the
MENU
button until the required function is showing on the
display. Select the function by pressing the
ENTER
button and the display will blink. Use the
DOWN
and
UP
button to change the mode. Once the required mode has been selected, press the
ENTER
button to setup to go back to the functions without any changes press the
MENU
button
again. Hold and press the
MENU
button for one second or wait for one minute to exit the menu
mode.
8C