DTP-125 MANUAL TENSIONER
Part No. 306155
GENERAL SAFETY CONSIDERATIONS
1.
EYE INJURY HAZARD.
Failure to wear safety glasses
with side shields can result in
severe eye injury or blindness.
Always wear safety glasses with
side shields which conform to
ANSI Standard Z87.1.
2.
STRAP BREAKAGE HAZARD.
Improper operation of the tool or sharp corners
on the load can result in strap breakage during
tensioning, which could result in the following:
PPPP
A sudden loss of balance causing you to fall.
PPPP
Both tool and strap flying violently towards
your face.
Failure to place the strap properly around the
load or on an unstable or shifted load could
result in a sudden loss of strap tension during
tensioning. This could result in a sudden loss of
balance causing you to fall.
Read the tools operating instructions. If the load
corners are sharp use edge protectors. Place the
strap correctly around a properly positioned load.
Positioning yourself in-line with the strap, during
tensioning and sealing, can result in severe
personal injury from flying strap or tool. When
tensioning or sealing, position yourself to one
side of the strap and keep all bystanders away.
3.
FALL HAZARD.
Maintaining improper footing and/or balance
when operating the tool can cause you to fall. Do
not use the tool when you are in an awkward
position.
4.
CUT HAZARD.
Handling strap or sharp parts
could result in cut hands or
fingers. Wear protective
gloves.
5.
TRAINING.
This tool must not be used by persons not
properly trained in their use. Be certain that you
receive proper training from your employer. If
you have any questions contact your Acme
Representative.
6.
TOOL CARE.
Take good care of the tool. Inspect and clean it
daily, lubricate it weekly and adjust when
necessary. Replace any worn or broken parts.
7.
WORK AREA.
Keep work areas uncluttered and well lighted.
SPECIFICATIONS
Strap Type
Width
Thickness
RD / SupraMet
3/4"
.020 Minimum
Hi Tensile
1 1/4"
.035 Maximum
OPERATING INSTRUCTIONS
1.
Encircle the bundle with the strap threaded
through a pusher seal as shown. Be sure the end
of the lower strap is bent back beneath the seal.
© Copyright 2008, Acme 512161 Rev. 11/2008