Ackermann
Page: 11 // 18
SHAVER SYSTEM
8.3. coNTRoL bUTToNS
8.3.1. PowER SwITcH
The AC power switch is used to switch the device on and off.
8.3.2. oN/off
The push button ON/OFF activates/deactivates
the device.
To activate device:
Press the push button ON/OFF. The ON LED light
green and the STANDBY LED goes out.
To deactivate device:
Press the push button ON/OFF. The STANDBY
LED light yellow and the ON LED goes out.
8.3.3. START/SToP
The push button START/STOP puts the device
into operation and stops it.
To start device:
Press the push button START/STOP. The START LED
light green and the roller wheels can be set in motion
using the pneumatic control.
To stop device:
Press the push button START/STOP. The STOP LED
light yellow and the START LED goes out.
The pneumatic control is inactive.
8.4. operaTIon of THe DevICe
1 . You can start the device after carrying out a functional check.
2. The pump is activated, the ON LED light green, the STOP LED light yellow.
3. Start the pump by pressing the push button START/STOP. The START LED light green.
4. Pressing the red button on the manual control I right footswitch on the double footswitch starts the SUCTION roller
wheel moving and pressing the blue button left footswitch the IRRIGATION roller wheel. The stronger the pressure exerted,
the greater the flow rate (can be seen on the the bargraph displays). If pressure on the button is released, the pump stops.
The suction and irrigation processes cannot both take place at the same time. After every irrigation process lasting longer
than 1.5 sec, the roller wheel (IRRIGATION) turns 1 revolution in the reverse direction in order to prevent the irrigation fluid
from dripping.
5. Stop the device by pressing the push button START/STOP. The STOP LED light yellow.
6. Deactivate the device by pressing the push button ON/OFF. The STANDBY LED lightyellow.
7. Switch off the device at the AC power switch.
