32 English
Setup
Language
Source Lock
Auto Keystone
Keystone
Sleep Timer (Hours)
Direct Power On
DC 5V Out
High Altitude
HDMI EDID
Reset
Setup
Select
Exit
Enter
English
Off
Off
Auto
Off
Off
Off
Language:
Set the language for the OSD.
Source Lock: Select On to
lock the current source as the only available source,
even if the cable is unplugged.
Auto Keystone: Select On to
automatically adjust image distortion caused by tilting
the projector.
Note:
The Auto Keystone function can be only used to adjust the image distortion vertically.
Keystone:
Adjust image distortion caused by tilting the projector (+/-40 degrees).
Note:
If you adjust the keystone degrees manually then the Auto Keystone function will be
automatically switched off.
Sleep Timer (Hours):
Set the sleep timer duration. The sleep timer will start with or
without a video source. The projector will automatically shut off after the selected
time. Options are:
Auto
,
Off
,
0.5
,
1
,
3
,
8
,
12
.
Note:
If the Sleep Timer is set to“Auto” then the project will automatically power off after 15
minutes if no video source has been detected.
Direct Power On:
Choose
On
to activate Direct Power mode. The projector will
automatically power on when AC power is applied, without pressing the
Power
button on the projector control panel or on the remote control.
DC 5V Out:
Choose
On
to enable DC 5V output function when using either of the
USB connectors: USB1 or USB2.
Note:
This feature varies depending on the device.
High Altitude:
When “On” is selected, the fans will spin faster. This feature is useful
in high altitude areas where the air is thin.
HDMI EDID
: Select the HDMI EDID type from
2.0
or
1.4
.
