![background image](http://html.mh-extra.com/html/acer/veriton-3000/veriton-3000_service-manual_6262106.webp)
74
Chapter 4
Parallel port test failed
1. Make sure the parallel port is enabled in BIOS setup utility.
2. Make sure the internal cable from the parallel port to the
main board is well connected (if applicable).
3. Replace the main board.
Serial ports
NOTE: Execute “Load BIOS Default Settings” in BIOS Setup to confirm the port’s presence before diagnosing any
serial port problems.
Serial port loop-back test failed.
Serial port test failed.
1. Make sure that the serial port you test is properly set in
BIOS Setup.
2. Ensure that the internal cable from the serial port to the main board
is properly connected.
3. Make sure that the serial port you test is the same one that you
tested in the diagnostic program.
4. Replace the loop-back (if applicable).
5. Replace the main board.
Serial port failed.
1. Make sure that the serial port you test is properly set in
BIOS Setup.
2. Make sure that you are connected to the right serial port.
3. Ensure that the internal cable from the serial port to the main board
is properly connected
(if applicable)
.
4. Ensure that the device driver is properly installed. Refer to the
device manual.
5. Check the external cables and connections which are connected to
the serial device.
6. Replace the serial device.
7. Replace the main board.
Keyboard
Keyboard test failed.
1. Make sure that the keyboard is properly connected to the keyboard
connector (not mouse connector) of the system.
2. Reconnect the keyboard, reboot and test it again.
3. Try another keyboard.
Some or all keys on the keyboard do not work.
1. Replace the keyboard.
Pointing device
Pointing device failed.
1. Make sure that the pointing device is properly connected to
the system.
2. Make sure that the pointing device setting is enabled in the BIOS
setup utility.
3. Make sure that the pointing device driver is properly installed.
4. Try another pointing device to make sure that the device is
good.
5. Replace the main board.
USB device
USB device failed.
1. Make sure that the USB port is enabled in the BIOS setup
utility.
2. Make sure that the USB device is properly connected to the system.
3. Try another USB device to make sure that the device is
good.
4. Replace the main board.
Power supply
NOTE: To test a stand-alone power supply, connect the external power source (power cord) and any of its load
(e.g., hard disk drive), locate the green line from the power header, and connect it to a black line. Then turn
on the override switch (situated on the back of the power supply). If the power supply fan turns on, the
power supply is fine.
Pressing the power switch does not turn off the system.
(Only unplugging the power cord from the electrical
outlet can turn off the system.)
1. Ensure that the
Power Switch < 4 sec.
in BIOS Setup
of
Power Management
is not set to
Suspend
.
2. Make sure that the power switch cable assembly is
connected properly to the main board.
3. Replace the power switch cable assembly.
Error Symptom
Action/FRU
Summary of Contents for Veriton 3000
