26
En
gl
ish
"H. Position", "V. Position", "Frequency" and "Tracking" functions
are not supported under HDMI, DVI or Video mode.
"Sharpness" function is not supported under HDMI, DVI or computer
mode.
PIP, PIP source, PIP Location and PIP Size are not supported under
Video mode.
Keystone
Adjust image distortion caused by tilting projection. (±40 degrees)
H Keystone
Press the
or
to adjust image distortion horizontal and makes
a squarer image.
V Keystone
Press the
or
to adjust image distortion vertical and makes a
squarer image.
H. Position
(Horizontal
position)
•
Press
to move the image left.
•
Press
to to move the image right.
V. Position
(Vertical position)
•
Press
to move the image down.
•
Press
to move the image up.
Frequency
"Frequency" changes the projector's refresh rate to match the
frequency of your computer’s graphics card. If you can see a vertical
flickering bar in the projected image, use this function to make the
necessary adjustments.
Tracking
Synchronizes the signal timing of the projector with the graphics card.
If you experience an unstable or flickering image, use this function to
correct it.
Sharpeness
Adjusts the sharpness of the image.
•
Press
to decrease the sharpness.
•
Press
to increase the sharpness.
PIP
•
Choose "On" to to see two screens at the same time.
•
Choose "Off" to disable the function.
PIP Source
Press
and
to choose the secondary video source: Composite,
S-Video or Component signal.
PIP Location
Choose the PIP secondary signal location on the display screen.
PIP Size
Choose the PIP secondary signal size on the display screen.
