C h a p t e r 3
C h a p t e r 3
BIOS Setup Information
BIOS Setup Information
3-1
The Setup Utility is a hardware configuration program built into your computer’s BIOS (Basic
Input/Ouput System).
Your computer is already properly configured and optimized, and you do not need to run this utility.
However, if you encounter configuration problems, you may need to run Setup. Please also refer
to Appendix E, BIOS Post Checkpoints when a problem arises.
To activate the Setup Utility, press F2 after you hear a beep while the Extensa logo is being
displayed.
When Silent Boot (described later in this chapter) is disabled, a message displays telling you when
you can press F2 to run the Setup Utility.
BIOS V3.0
------------------------------------------------------------------------------------------------------
016384 KB Memory Good
Enter Setup, Press F2 Key
------------------------------------------------------------------------------------------------------
ACR58000-M12-970324-R01-A0-EN
Copyright
Acer Incorporated 1990-1997. All Rights Reserved
Summary of Contents for 390 Series
