eBoard Installation guide
4
2. Receiver Installation.
2.1
Preparation
.
ACE eBoard is designed to be installed easily. The first step is placing two receivers
correctly on the top of your whiteboard frame or mounting on the flat surface.
Before installation, you firstly need to check each receiver carefully. ACE eBoard consists of
2 receivers and each unit is connected by cable. The left receiver has two cables, one is for
the USB connection cable and another is the link cable to right receiver. On the other hand,
the right receiver has just 1 link cable from the left receiver. When you install the receivers,
you have to be always careful for its right position. Please keep in mind that it wouldn
’t work
properly when receiver position is wrong.
In order to use full whiteboard surface as effective working area, please position each
receiver on the upper-left corner and upper-right corner of your whiteboard frame, if possible.
For your information, this device is designed to support 100 inches at maximum.
2.2 Installation
Usually, the width of whiteboard frame is not standardized and diversified from thin to thick
frame. Or you may need to mount receivers on the flat surface directly without whiteboard.
To support various configurations like them, ACE eBoard includes acryl holders and steel
brackets for easy installation, which are suitable for each specific environment.
2.2.1 For whiteboard using thick frame on the Stand or hung on the wall.
This type of whiteboard is normally found in most customer environment and very easy to
adhere receiver on the top of the whiteboard frame because it has enough space to place
receivers. For this configuration, please just fix receiver directly on the top of whiteboard
frame using double-sided sticky tape enclosed in gift box without using acryl holder or steel
bracket.
2.2.2 for whiteboard using thin frame on the Stand.
For this type of whiteboard, the width of its frame is not enough to hold receivers completely.
Instead, it is more convenient for you to use acryl holder enclosed in gift box. For doing it
properly, please assemble the acryl holder with receiver as shown below, and then place
each receiver correctly on the left and the right top of whiteboard frame after taking off
masking tape on the sticky tape and push acryl holder lightly to be glued at the top-front side
of whiteboard frame.
