Chapter
4 Configuration
Installation and Operation Manual
4-56
Configuring for Operation
ACE-3105, ACE-3205 Ver. 5.2
ACE-3205 – RAD Data Communications
Configuration> Logical layer> PPPoE
1. ID ... (1)
2. AC name ... (-)
3. Service name ... (-)
4. Scheduled restart > (Disabled)
5. Scheduled restart time [HH-MM-SS] ... (00:00:00)
6. Scheduled restart random range (sec) ... (3600)
7. Back-off random range (sec) ... (0)
8. Minimum authentication level ... (PAP)
9. Username ... (-)
10. Password ... (-)
11. Confirm password ... (-)
12. VLAN tagging > (Enable)
13. VLAN ID ... (0)
14. VLAN priority ... (0)
15. Bind interface >
16. IP translation > (Disable)
17. Translated IP address ... (0.0.0.0)
>
Please select item <1 to 16>
ESC-Previous menu; !-main menu; &-exit
Figure
4-44. PPPoE Menu
Table
4-37. PPPoE Parameters
Parameter Description
Possible
Values
ID
The identifying number of the PPPoE logical
entity
1–4
AC name
Name of the access concentrator (AC)
server with which the PPPoE session should
be established. If the AC name is not
specified, ACE-3105, ACE-3205 attempts to
establish the PPPoE session with the router
whose response was received first.
Up to 32 characters
Default: NULL
Service name
The name of a specific service requested
during this PPPoE session.
Note: If the access concentrator (AC) does
not support the requested service, the
session will not be enabled.
Up to 32 characters
Default: NULL
Scheduled restart
Enable or disable the scheduled restart
mechanism for this PPPoE entity.
When enabled, the PPPoE session is
restarted locally at around the time
specified below.
Enabled
Disabled
Default: Disabled
Scheduled restart
time
The time around which the restart should
take place (depending on the random delay
set below). Relevant only if the scheduled
00:00:00 – 23:59:59
