A111 Pulsed Coherent Radar (PCR)
Datasheet, v1.8
© 2019 Copyright by Acconeer
2019-06-12
Page 28 of 34
9.2 FCC Approval
Hereby, Acconeer declares that the A111 sensor has modular approval granted by FCC for the
following software configuration profiles:
-
Maximize depth resolution
-
Maximize SNR
The configuration of the A111 sensor is done through two different profiles with different emission,
which are covered in the conformity test that Acconeer has conducted at accredited test house. The
two profiles are called maximize depth resolution and maximize SNR. When certifying a given use
case the sensor should be configured with the longest range window applicable to the use case and the
fastest update rate supported by the application.
The A111 sensor meets the title 47 of the Code of Federal Regulations, part 15 section 15.255 for
intentional radiators operating in the 57-71 GHz band for the following type of applications.
- Field disturbance sensor employed for fixed operations.
- Short range device for interactive motion sensing.
Warning: The end user needs to maintain 20 cm distance to radiating parts of the device.
FCC ID: 2AQ6KA1
The host product manufacturer is responsible for compliance to any other FCC rules that apply to the
host not covered by the modular transmitter grant of certification.
9.2.1 FCC Regulatory Notes
Modifications
Aconeer has not approved any changes to this device. Any changes or modifications to this device
could invalid the FCC approval.
Interference statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
RF exposure
This device complies with the FCC radiation exposure limits set forth for an uncontrolled
environment. Co-location of this module with other transmitters that operate simultaneously are
required to be evaluated using the FCC multi-transmitter procedures.
The RF exposure has been calculated with a 20 cm separation distance I.e. Mobile devices.
Labelling requirements for the host device
The host device shall be labelled to identify the modules within the host device, which means that the
host device shall be labelled to display the FCC ID of the module preceded by words "Contains
transmitter module" or "Contains", E.g.
Contains FCC ID: 2AQ6KA1
