The projector will detect the lamp life itself. It will show you a warning
message
“Lamp may fail soon! Replacement Suggested!”.
When you see this
message, please contact your local reseller or service centre to change the
lamp as soon as possible. Make sure that the projector has cooled down for
at least 30 minutes before changing the lamp.
27
A P P E N D I C E S
CHANGING THE LAMP
Lamp compartment is
hot! Allow it to cool
down before changing
the lamp!!
WARNING
!
To reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if
dropped.
WARNING
!
■
Lamp Changing Procedure
1
Turn off the power to the projector by pressing
the “Power / Standby” button.
2
Allow the projector to cool down for at least 30
minutes.
3
Turn off the main power switch.
4
Disconnect the power cord.
5
Use screwdriver to remove the screw from the
cover.
6
Remove the cover.
7
Remove the two screws from the lamp module.
8
Pull out the lamp module.
To replace the lamp module, reverse these steps.
Summary of Contents for NOBO X20M
Page 2: ...2...
