Acclaim Lighting Unity SNS2019, User Manual

Page: 12 / 56

10
USING A PIPE CLAMP
Optional pipe clamps are available to mount Unity fixtures on either 2” (50mm) or 4”
(100mm) (Schedule 40) tubes and poles.
IMPORTANT: Ensure the pipe (Schedule 40) and its mountings have sufficient load
capacity for the Unity fixture(s) to be mounted.
TO USE A PIPE CLAMP
1 Separate the two halves of the clamp, if they are already bolted together.
2 Place the two halves of the clamp around the pipe.
3 Use the two longer bolts,
one from each side to join
the two halves - see below
about the correct use of the
supplied washers.
4 Tighten the two main bolts
evenly until the clamp is
held firmly in place.
5 Use the two smaller bolts
(with spring and standard
washers) to fix the Unity
yoke to one side of the
clamp and tighten.
6 Secure the feed cable neatly
and securely along the pole.
(2 off)
M10 x 50mm
Using the supplied washers
The supplied spring washers
help to maintain tension on the
bolts to prevent loosening.
Always place the spring
washer on each bolt
first and then add
the standard washer,
before inserting the
bolt into the clamp.
This will prevent the
steel spring washer
from denting the softer
aluminum body of the
clamp.
(2 off)
M10 x 25mm
Schedule
40 pipe