Acclaim Lighting Dyna Accent, User Manual

Page: 6 / 24

4
www.acclaimlighting.com
Ø113mm
Ø109mm
63mm
63mm
15mm
INSTALLATION
MOUNTING
The base plate of the Dyna Accent can be directly
mounted onto a standard 4” round electrical outlet
box of sufficient strength for the weight of the fixture.
The data and power cables are fed through two glands
in the base plate so allowance should be made for
passage of the cables if mounted on a flat surface. You
should use screws/bolts with countersunk heads (less
than Ø7mm) in order to avoid interfering with the pan
rotation of the fixture.
Base pivot
point (offset
from center) Cable gland
4 x mounting
holes (Ø4mm)
with Ø7mm
recess on top
surface
The dimensions of the underside of the base are
shown below (at 75% of actual size):
Standard 4” round electrical outlet box (not supplied)
Silicone gasket
Note: It is important to use countersunk screws/bolts that fit flush within the countersunk
mounting holes as the rotatable base of the fixture overlaps the two rear holes.