Acclaim Lighting Ai Flex Interior, User Manual

Page: 11 / 40

9
www.acclaimlighting.com
TO FIT A LENS
1 Measure the exact length of lens required
between the end caps at each end of the channel.
2 Carefully cut the lens to length. Ensure that any
resulting burrs are removed.
3 Insert one end of the lens against one of the end
caps so that it locates into the ‘Lens recess’ within
the channel (see right).
4 Once the first part of the lens has correctly
located, run your thumb gently along the length
of the lens to push the remainder into place.
Locate the first section of
lens into the channel and
then run your thumb along
it to push the remainder into
place.
TO SURFACE MOUNT
1 Fit the Ai Flex tape to the channel (see Page 8).
2 At the end where the connection will take place,
fit an End cap with hole .
3 Feed the link cables through the end cap and
carefully solder to the contact pads, if necessary
(see page 5).
4 At the other end of the channel, fit a standard End
cap
.
5 Fit the required lens (see below).
6 Attach two or more
Zinc mounting brackets
to the
mounting surface using screws appropriate to the
surface type.
7 Clip the channel into the
mounting brackets using
the slots shown here:
Attach the
channel to the zinc
mounting brackets
Solder the link
cables to the
contact pads
+24
V
W1
W2
W3
W4
Lens
recess
Note: Ensure sufficient
strain relief where the
cables enter the channel.