Access Virus Rack XL, User Manual

Page: 80 / 194

80
CHAPTER 7
The Parameters
- ASSIGN A freely selectable sound parame-
ter for LFO modulation. The destination can
be controlled on the previous menu page.
01111111111111111112
1 LFO 1
Amount 12≤
61111111111111111154
LFO 3
CLOCK
When you set it to OFF, the LFO oscillates in the
normal manner, independently of the global
Master Clock (CLOCK TEMPO). When you en-
ter a note value here, the LFO rate is synced up
to the global master clock. The length of the
waveshape’s cycle will then correspond to the
note value that you have entered. You can also
set the rate via CLOCK TEMPO (refer to the ap-
propriate section) or synchronize it to external
MIDI clock. When the LFO is synced up to the
master clock, you can also select the desired
note value via the LFO RATE knob.
01111111111111111112
1 LFO3
Clock 1/24≤
61111111111111111154
MODE
- POLY In polyphonic mode, each of the voic-
es involved is assigned a dedicated LFO. The
LFOs oscillate in different phase positions for
each voice. This livens up the LFO modula-
tion.
- MONO In polyphonic mode, all voices are
assigned the same LFO. This accentuates the
LFO modulation, making it more pronounced.
01111111111111111112
1 LFO3
Mode Poly≤
61111111111111111154
ENV MODE
Activates an operating mode in which the LFO
oscillates like an envelope: The LFO cycles
once only following the start of the note; the re-
sponse of the LFO shifts from bipolar to unipo-
lar. If the LFO waveshape S&H (Sample & Hold)
is active, then the LFO is assigned a new ran-
dom value with each new note. This new value
is valid for the entire duration of the note.
01111111111111111112
1 LFO3
EnvMode Poly≤
61111111111111111154
DESTINATION
Determines the modulation destination of the
LFO. You can select from:
- OSC 1 The pitch of Oscillator 1
- OSC 1+2 The pitch of both oscillators
- OSC 2 The pitch of Oscillator 2