Page
5
of
16
Copyright © Access-IS 2018
2. Installation
The ADR100 is simple to install. You can connect the product before or after you install the
Access-IS Document Reader Software (ADRS) on the host computer.
Refer to
Installing the software
(on page 9) for software installation instructions.
2.1 Opening the box
Unpack the ADR100 and ensure that you have the following items:
•
Advisory notice card.
•
ADR100 Photo ID Reader.
•
USB 2.0 cable.
•
24 V DC power supply unit.
Report any missing items or damage immediately to your Sales Representative.
2.2 Connecting the ADR100 to the host
Connect the ADR100 directly to a USB port on the host computer. Ensure that the host is running
Windows XP or above.
Note: The ADR100 is approved for use with a USB cable no longer than 3 m total length. If a longer
cable is used, you should fit a DC EMC filter to the power supply. Please contact the Access-IS
support team for details.
1. Plug the white Molex power connector into the 24 V DC power supply supplied by Access-IS or
your own power supply unit.
2. Plug the micro USB connector into the ADR100.
3. Ensure the power supply is connected to an available power outlet using a suitable IEC power
cord.
4. Connect the other end of the USB cable to a USB 2.0 socket on the host PC.
When you connect the ADR100 to a USB port, Windows automatically detects the device and
installs the required standard Windows drivers, which may take a few minutes.
5. Install the software (see
Access-IS Document Reader Software
(on page 9)).
No additional drivers are needed.
