4: Port configuration
Port configuration and status
Status
Indicates the status of the port.
•
Green: The port is up and running.
•
Blue: The port is enabled and a signal is detected.
•
Red: The port is enabled but the physical link is down and no signal is detected.
•
Yellow: The port is not totally functional.
•
Grey: The port is disabled.
Connector
Identifies the physical connector the port is using.
Port name
Identifies the logical name assigned to the port.
Port state
Indicates if the port is enabled (ready to connect) or disabled.
Speed
Indicates the current port speed and duplex type. If set to Auto-nego the EtherNID automatically negotiates port speed
and duplex type with the device it is connected to. For this to work the device must also be configured to support auto-
negotiation.
MAC address
Indicates the MAC address of the port.
Port options
Media-selection
(Supported on the EtherNID GE and MetroNID TE / TE-R / TE-S only)
Lets you select which two media connectors will be used to carry traffic.
These four options are available on the EtherNID GE and MetroNID TE / TE-R:
•
SFP-A with SFP-B
•
SFP-A with RJ-45-B
•
RJ-45-A
with
SFP-B
•
RJ-45-A
with
RJ-45-B
Summary of Contents for EtherNID EE
