ACARD AEC-6280
15
Chapter 4
System Installation
4.1
DOS Environment
For Boot Device
1. Complete
ACARD AEC-6280
hardware installation.
2. Boot-up the computer, press <Del> to enter the motherboard’s BIOS
setup. Then change “
Boot Sequence
” to A:.
3. Restart the computer by a DOS bootable floppy and run DOS FDISK.
Then create a Primary partition onto the hard drive.
4. After re-booting to a DOS bootable floppy, run the DOS FORMAT
command.
Non Boot Device
1. Complete
ACARD AEC-6280
hardware installation.
2. Boot-up the computer, press <Del> to enter the motherboard’s BIOS
setup. Then change “
Boot Sequence
” to C:.
3. Restart the computer, and run MS-DOS and DOS FDISK. Then create
a Primary partition onto the hard drive.
4. After re-booting, run the DOS FORMAT command.