Secvest QuickGuide installation
Secvest QuickGuide installation
Secvest QuickGuide installation
Secvest QuickGuide installation
Please observe all country-specific safety instructions. The 230 V mains
power supply should only be connected by trained specialist
personnel.
Remove both housing screws from the bottom side of the
Secvest.
Fold the front housing side upwards and carefully pull the
ribbon cable from the PSU.
Fix the base plate on a suitable surface using the screws and
wall plugs provided.
Overview of the base plate:
No. Description
1
Cable clamp (tension relief) for the 230 V AC mains line
2
Connection socket for the connection cable
3
230 V AC mains connection
4
Connection clamps for wired zones and outputs
Install the 230 V mains connection with the power supply
disconnected and attach the cable clamps.
Optional:
Optional:
Optional:
Optional: Install the wired detectors to the zone inputs using
the resistors provided and/or connect the relay outputs, when
required. For further information, consult the installation
instructions.
Overview of the rear side of the Secvest:
Optional:
Optional:
Optional:
Optional: Connection for external loudspeaker (16 Ohm) and
external microphone -> item no. FU5230
Optional:
Optional:
Optional:
Optional: To use the integrated dialler, connect the analogue
line to the A/B connections. The return line can be connected
to A1/B1. The C/E connections are not used.
No. Description
1
Internal siren
2
Battery compartment
3
Internal loudspeaker
4
Connection for the analogue telephone line (PSTN)
5
Kickstart and Codes Defaulted jumper (KS + RESET)
6
Connection for external loudspeaker and microphone
7
Connection for extension modules (ISDN / GSM / ethernet /
GPRS)
8
Connecting cable between base plate and top part
9
Loudspeaker volume control
10
USB port
