Abus FUBE50061, Installation Instructions And User Manual

Page: 53 / 188

EN 21
8.7. Button assignment of wireless control panel for
controlling wireless alarm panel
8.7.1. Operating mode
The left button (11) of the wireless key switch is used for arming, and
always transmits the code “Button 1”. This button corresponds to button 1
in the Secvest installer mode menu “Other components

Wireless control
panel
 Edit wireless control panel”.
The right button (12) of the wireless key switch is used for disarming, and
always transmits the code “Button 4”. This button corresponds to button 4
in the Secvest installer mode menu “Other components

Wireless control
panel

Edit wireless control pane
l”.
By default, the buttons of a wireless control panel for use with a Secvest
FU500X wireless alarm panel (software version 2.xx.yy and 3.xx.yy) are
assigned as follows (factory settings):
Button 1: Arm all
Button 4: Disarm all
For arming and disarming the Secvest FU500x wireless alarm panel
(software version 2.xx.yy and 3.xx.yy), you do not need to make any
changes under this menu item of the wireless alarm panel.
Note
If you wish to use the wireless key switch to internally arm a partition or
switch outputs, go to the installer menu of the wireless alarm panel and
select “Other components

Wireless control panel

Edit wireless control
panel”, and select the relevant wireless control panel. Now you can
reassign buttons 1 and 4. The following options are available in
software version 2.xx.yy and upwards:
•
Arm all
•
Internal arming
•
Disarm all
•
Output z (on or off)