Abus AZWG10020, Installation And Operating Instructions Manual

Page: 89 / 301

13 UK
9. Installation
Open the housing by removing the screws on the bottom. Now you can tip
up the front part and unhook it at the top. The assembly is in the reverse
order: hook the front part in at the top, fold it together, and tighten the
screws.
Caution!
Disconnect the device from the power before performing any wiring work.
Please check the following prior to installation and mounting of the device:
The type of analog telephone connection
The account type of the GSM connection
The physical location of the device and its antenna
The GSM reception (sufficient and largely problem-free reception)
9.1 Location for device and antenna
If you want to access a cellular network with the device, you need to find a
suitable location. The device itself should be placed at a location which is
convenient for the user as well as favorable for laying cable. You also need
to place the antenna so that you can get a good signal from the cellular
network. The antenna cable is approx. 3 m long. Also look for a smooth, dry,
and vibration-free surface at the place of mount.
Verification of sufficient signal strength of the cellular network
There are three ways to check the signal strength at the installation location:
1.
You can use a mobile phone. It must be registered on the same network as
the SIM card you intend to use with the device.
If your phone displays at least three signal bars at the location of the device
antenna, then the device should be able to work in this network. It is not
enough to rely only on the signal strength indicator.
Make sure that you can make a call from the selected position.