Abus AZWG10020, Installation And Operating Instructions Manual

Page: 101 / 301

25 UK
If you have selected the “Outputs
 Output Polarity = Positive” menu item:
Output status Status of the external device, e.g.
LED
Deactivated ON
Activated OFF
If you want to trigger an external device with the voltage potential of the
output only in terms of potential, wire the output as shown in the above
example wiring diagram. The resistor R s
hould have a value of approx. 1 kΩ.
You will then have the following potentials at point “X”:
Output status Menu setting:
Output Polarity =
Positive
Menu setting:
Output Polarity =
Negative
Deactivated Negative Positive
Activated Positive Negative
In the programming menu, you can separately set whether each of the four
outputs takes on a negative or positive potential when activated.
10. Putting into operation
Once all necessary connection work has been completed, close the housing.
Details can be found at the beginning of Section 9 (Installation).
You can now begin putting the product into operation.
Supply power to the device.