Absco Industries
Assembly Instruction Manual
ABSCO WORKSHOP SHED
MODEL: 60303WECOK
5.96mW x 3.00mD x 2.10mH
Model: 60303WECOK
06/02/2019
1.10
26
CENTRE PORTAL FRAME DETAILS
PART C1482
2950mm
80mm
80m
m
NOTE: If you have a slab with an edge rebate in your concrete slab, you will have to cut an amount
off the bottom of the frame legs equal to the depth of the rebate.
TIP: An easy way to make sure that the angle
at the top of the portal frame is correct is to
use the gable wall panel as a template to lay
the sections out. As the portal frame fi ts inside
the walls, the width of the frame will be 40mm
less than the gable wall panel.
NOTE: Refer to the section
CENTRE PORTAL ASSEMBLY for
photos of the process.
1783mm
2x Apex plates
1x Knee plate
1x Knee plate
PART C1704
2045mm
1 required.
