Part number 20219, Rev 0
4
INSTALLATION INSTRUCTIONS
UNCRATING
Move your refrigerator as close to the
final location as possible before
unpacking. Remove the carton and
the styrofoam strips. The location
should be as close as possible to the
power outlet so no extension cord is
needed.
LEVELING
You can level your unit with the screw-
type adjustable leveling legs on the front corners of the unit. Turn counterclockwise to raise
the corner; turn clockwise to lower it. Leveling legs are required in front only. Unit may
have a slight tilt from front to back. This is acceptable and is recommended on this unit.
POWER SOURCE
The supply circuit to this cabinet must
conform to all National and Local Electrical
Codes. Consult the cabinet Serial-Data
plate for voltage, cycle, phase, and amp
requirements before making connection.
VOLTAGE SHOULD NOT VARY MORE THAN
5% FROM SERIAL PLATE RATINGS. A
separate circuit is recommended to prevent possible loss of
product due to over-loading or failure of other equipment
on the same circuit. PROTECT THE CIRCUIT WITH A 20 AMP
DELAY-TYPE FUSE OR CIRCUIT BREAKER. Do not use an
extension cord. Be sure your unit is properly grounded.
Use the 3-prong plug provided into a 3-prong grounded
outlet. (Only this method complies with national electrical
codes, local codes and ordinances.) Unless the above
grounding method is followed, you are not protected
against severe or lethal shock in the event of a short circuit
of an electrical component or wiring of the unit.
