Installation –
Installing the eMH3 Wallbox on the POLEMH6 |
25
NOTE
Dehumidifying the POLEMH2
To dehumidify the interior, we recommend filling the base area of the POLEMH2 with dry granulate. This minimis-
es any unwanted effects due to condensation and seepage water penetration.
Installing the eMH3 Wallbox on the POLEMH6
This section describes how to install the eMH3 Wallbox on the POLEMH3.
Proceed as follows:
1
Remove the large grommet on the front of the
mounting pole, use a cutter to cut an opening for
the supply cable in the membrane of the grommet
and then replace it.
y
If you also want to lay data cables into the
wallbox, cut both smaller grommets, too.
2
Screw the mounting plate of the eMH3 Wallbox to
the front of the mounting pole using the hexagon
screwdriver and the four M8×25 half-round head
screws supplied.
3
Open the housing cover of the wallbox using the
triangular key and lower it.
