|
Mechanical and electrical installation
20
Proceed as follows to set up the energy meter:
1
Press and hold the enter key
for about 3 seconds.
y
The password entry menu will be displayed.
≥3S
NOTE
Enter the factory default password
A password is required in order to set up the energy meter. This is set as
0
by default.
2
If a value other than
0
is displayed, press the toggle
key
until
0
appears on the display and hold the
enter key
for about 3 seconds to confirm.
y
The
CnGPASS
menu will be displayed.
≥3S
WARNING!
Changing the factory default password
If required, you can set a new password between
000
and
999
via the
CnGPASS
menu to protect the energy me-
ter against unauthorised access.
To change the password, briefly press the enter key
, select a new password with the toggle key
, then
confirm the new password by holding the enter key
for about 3 seconds.
If you change the password, you must keep it in a safe place for reference.
NOTE
Skipping unnecessary menus
To give a better overview, only menus relevant to the setup are described below. Unnecessary menus (such as
APPliC.
,
SEnSOr
, etc.) are not mentioned and can be skipped when selecting menu options.
3
Use the toggle key
to select the
SYS
menu and
briefly press the enter key
.
≤1S
≤1S
