MF1-Laser Front/Rear
9 Maintenance and cleaning
EN - 23
9.1 Inspecting the wire guide nipple
9.2 Maintenance intervals
When using arc welding equipment, always observe the provisions of EN 60974-4 Inspection and testing,
as well as any national laws and regulations.
Check the following:
1
Wire guide at the MasterLiner wire inlet
2
Wire guide nipple between the drive wheels
3
Wire guide actual value transmitter
Fig. 19
Wire guide nipple MF1
1
2
3
NOTICE
• The specified maintenance intervals are standard values and refer to single-shift operation.
• Visually inspect the toothed wheels once a week.
• The higher the rocker arm force, the greater the wear to the toothed wheels.
Daily
Weekly
• Visual inspection for abrasion or damage to the wire feed rolls.
Basic cleaning is recommended, and necessary in the event of
extreme working conditions.
Blow compressed air through the wire conduit and check for
wear.
Tab. 15
Maintenance intervals