Abicor Binzel iCAT mini, Operating Instructions Manual

Page: 58 / 148

EN - 24 BAL.0361.0 • 2021-02-25
6 Commissioning iCAT mini
6.5.4 Mounting the welding torch neck ABIROB
®
W (iCAT mini with wire brake)
1 Equip the welding torch neck ABIROB
®
W (1) with tip adaptor, contact tip, and
gas nozzle.
2 Insert the neckliner (3) in the torch neck until it stops.
3 Insert the positioning pin (2) in the hole (5) at the welding torch/cable assembly
interface (4) . The welding torch neck ABIROB
®
W (1) may be attached in this
position only.
4 Using the connection nut (6) , screw the welding torch neck ABIROB
®
W (1) to the welding
torch/cable assembly interface (4) .
NOTICE
• The torch neck for the wire brake must be equipped with the neckliner intended for this
purpose. The neckliner used depends on the wire diameter and the welding torch
geometry.
• Check all connections and sealing rings regularly for damage and to ensure they are
secure. Replace as needed.
• Consult the documentation for the welding components.
1 Welding torch neck
ABIROB
®
W
2 Positioning pin for
torch orientation
3 Neckliner
4 Welding torch/
cable assembly
interface
5 Hole for
positioning pin for
torch orientation 6 Connection nut for
welding torch
Fig. 13
Mounting the welding torch neck
ABIROB
®
W
(
iCAT mini
with wire brake)
1 2
3
4 5
6