EN - 16
7 Operation
BRS-LCi
6.11 Connecting the pneumatic system
For the supply line, a compressed air hose with an inner width of min.
ø
6mm is necessary which is fastened
to the support by means of a screw connection (not included in the scope of delivery). A shut-off valve in the
supply line is advantageous. This allows the BRS-LCi to be quickly and simply depressurized in order to carry
out any installation and maintenance work.
7 Operation
1
Switch on the robot control.
2
Start the welding process.
3
Stop the welding process.
8 Putting out of operation
1
Switch off the robot control.
Fig. 13
Connecting the pneumatic system
S1
M
M
Z2
Z1
5
3
1
4 2
12
14
5 3
1
4
2
12
14
5 3
1
4
2
12
14
E
P
V
S2
S4
Y2
Y1
Y3
Y4
Compressed air of motor
Clamping cylinder
Lifting cylinder
Sucks from the
cylinder
Y2
Y1
Y3
6 bar
S3
D8/d6
slove
stretch
down
above
Compressed air of motor
S3
D8/d6
D8/d6
D6/d4 D6/d4
D6/d4
D6/d4
D6/d4
D6/d4
D8/d6
D8/d6
D6/d4
NOTE
• As the cleaning station BRS-LCi is integrated into a welding system, the operating instructions of the
welding components, such as welding torch and robot control, must be observed during operation.
• Make sure that the BRS-LCi is operated with a front sheet only.
NOTE
• As the cleaning station BRS-LCi is integrated into a welding system, putting out of operation depends
on the robot control. Please make sure that the shutdown procedures for all components mounted in
the welding system are strictly observed.
