Abicor Binzel ADF 600S, Operating Instructions Manual

Page: 23 / 132

ADF 600S 2 Safety
EN - 5
2.5 Warning label
The following warning label is found on the product:
• This marking must always be legible. It must not be covered, hidden, painted over or removed.
NOTICE
Describes the risk of impairing work results or potential material damage to the equipment.
1 Warning label
Fig. 1 Warning label
1
Symbol Definition
This warning label must not be removed, destroyed or covered.
Read the information on this label and in the operating instructions carefully before using this helmet.
1. Before welding or cutting, you must ensure that the darkening visor provides adequate eye protection
for the relevant welding or cutting operation.
2. Always wear safety goggles that are certified in accordance with CE, ANSI/CSA or AS/NZS when
using this helmet. The front cover (i.e., the shock-resistant visor at the front of the helmet) MAY CRACK and
does NOT offer special protection against projected parts, spatter and spray.
3. Damage and scratches will impair vision and significantly reduce impact protection. To avoid injury,
replace damaged or scratched visors immediately.
4. Do not use for laser welding. Do not use for autogenous welding and cutting.
5. Please check this helmet at regular intervals and replace worn or damaged parts immediately before
using the helmet.
6. Caution: Welding processes may produce chemicals that can cause cancer or congenital
malformations (or other birth defects). Ensure adequate ventilation during welding.