EN - 8
5 Operation
ABIMIG
®
GRIP W
Using a standard welding torch, the two-cycle mode of the trigger can be
activated. Further operating modes and handle modules depend on the
corresponding welding power supply and must be ordered separately.
4.1 2-cycle function of the trigger
1
Press the trigger on the handle and keep it pressed = welding is started.
2
Release the trigger = welding is stopped.
5 Operation
1
Open the shielding gas cylinder.
2
Switch on the power supply.
3
Set the welding parameters.
4
Start welding.
6 Putting out of operation
1
Stop welding.
2
Wait until the shielding gas flow has subsided and then switch off the power
supply.
3
Close the valve of the shielding gas cylinder.
7 Maintenance and cleaning
NOTICE
• Liquid-cooled cable assemblies start leaking when overheated. This is
why the cooling unit should continue running for approx. 5 min. after
welding.
DANGER
Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of
maintenance, servicing, mounting, dismounting and repair work:
• Switch off the power supply and close off the gas supply.
• Pull the mains plug.