EN - 13
ABIDOT
6 Putting into operation
4
Retighten the hexagon socket screw
6.2.2 Mounting the ABIDOT on the welding torch
1
Dismount the gas nozzle from the welding torch and shorten the welding
wire end to approx. 5 mm.
2
Mount the
ABIDOT
on the torch and tighten it by hand.
NOTICE
• The minimum stick-out adjustment is 10 mm and can be adjusted in steps
of 1 mm up to a maximum dimension of 25 mm or 30 mm.
• When tightening the hexagon socket screw
, make sure that the
locking of the clamping piece
is correctly aligned to the
locking of the torch adaptor
Fig. 8
Shortening the welding wire end
NOTICE
• Depending on the welding torch version, you must also remove the
insulator or the gas diffuser.
• Remove any coarse dirt from the welding torch and tip adaptor.
• Do not use tools (pliers, etc.) to tighten the
ABIDOT
. An excessive
tightening destroys the
ABIDOT
.
ca. 5 mm
