Abex Exhibit Systems • 355 Parkside Drive, San Fernando, CA 91340 • (800) 537-0231
Insert the silicon edge of the fabric into
the groove of the extrusions.
Start on the corners, than centers and
work your way to corners from center on
both directions.
To pull fabric graphic out of extrusion
groove use pull tab on corner.
Extrusion fabric groove
SEG GRAPHIC
fabric graphic
w/silicon edge
3D VIEW
PAGE 2
SEG GRAPHIC
PACKING DIAGRAM
NOTE:
DO NOT DISCARD
ANY PACKING
MATERIAL.
LEVELS OF PARTS
MAY BE
SEPARATED BY
WHITE SHEETS OF
PLASTIC,
COROPLAST OR
CARDBOARD.
Attach wall bracket to top extrusion groove with
provided hammerhead screws. Locate position of
wall bracket on extrusion (preferably by wood
stud) by sliding the bracket on the extrusion and
tighten it. Secure the frame to the wall with
provided wood screw.
WALL ASSEMBLY (OPTIONAL)
LIGHTS DETAILS
Lights come attached to extrusions. Ensure all lighting strips are connected.
Once frame is assembled, connect strip-to-power cords to the end of top
and bottom lights chain.
- For bottom lights connect strip-to-power cord to power supply directly.
- For top lights connect extension cord to strip-to-power cord and run with
wire managment extrusion then connect to power supply.
Run AC power cord out through grommet hole on vertical upright and
connect to power outlet.
To remove or re-attach light strips use provided thumbscrews with plate.
Strip-To-Power Cord
EXtension Cord 12ft
