Abekas AirCleaner, User Manual

Page: 78 / 106

68 AirCleaner • User Guide
4. Operations
Programming AirCleaner
AirCleaner Menu Navigation
The AirCleaner menu system consists of three primary menu trees:
•
Main Menu
Consists of the Primary System Configuration: such
as configuring one- or two-screener mode, program
delay value, user reaction times, etc.
•
Options Menu
Consists of the Engineering Setup Parameters: such as
video format, reference source select, video timing,
etc.
•
User Memory Menu
Consists of three User Memory “Snap-Shots” of all
the system setup parameters. This provides a
convenient method to quickly save and recall pre-
defined setups.
Whenever AirCleaner is power on, by default the Main Menu is active in the control
panel. After power-on, the front-panel LCD display will show one of two display
screens:
(This displays the current software version)
or...
(The “Screeners” parameter is the first item in the Main Menu)
If the “
AirCleaner
” display is shown (instead of “
Screeners
”), then the
control panel had been programmed to be “locked out” from control, which prevents
accidental parameter changes to AirCleaner while it’s in use live, on the air.
Unlocking the control panel is a simple procedure, as described below.
WARNING DO NOT ADJUST PARAMETERS WHILE LIVE “ON-AIR”
Changes made to all parameters in the Main Menu will take effect
as the parameter is being changed. Depending on the parameter
being changed, this could disrupt the LIVE audio/video outputs!
Changes made to all parameters in the Options Menu require:
•
TURN the
SELECT
knob to reveal the “Save Changes?” item.
•
PUSH the
SET
knob to “OK” the save operation.
Saving any change to any parameter in the Options Menu could
severely disrupt the audio/video outputs from AirCleaner; these
changes should NEVER be saved while using AirCleaner live on
the air!
Model-1 / 2GB
V1.45A
Screeners
= One