![background image](http://html1.mh-extra.com/html/abbott/vp-2000-processor/vp-2000-processor_service-manual_450983234.webp)
Repair, Replacement of Spare Parts
Section 7
7-42
Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008
Removal
1. Remove the Hoods by gently squeezing inward on the two
(2) metal arms that connect the Hoods to the unit.
Remove the Carrier-Tray Assembly.
2. Remove the Top Cover by unscrewing six (6) 6-32 x 1/4
Phillips-Head screws, three (3) on each side of the unit.
3. Remove the Drip Tray, located in the lower center of the
unit, by grasping the flange on the tray from the rear of
the unit and lifting upward and out.
4. Remove the AC Power Barrier. Loosen three (3) 6-32 x 1/4
Phillips-Head screws at the ends of the barrier, and slide
the barrier back and up to remove it.
5. Remove the right-hand side panel by first removing the
four (4) 6032 x 1/4 Phillips-Head screws holding the panel
in place. Grasp the top of the side panel and pull it away
from the unit.
CAUTION:
Depress the plunger on the interlock
switches to permit the side panel to move past the
switches as it is pulled forward.
6. Remove the two (2) 6-32 x 1/4 Phillips-Head screws
fastening the AC Power Input Bracket to the right-hand
vertical support.
7. Pull the AC Power Input Assembly away from the system
and remove the two (2) screw-lock assemblies that hold
the computer connector in place.
8. Remove the three (3) leads to the AC Power Input
Assembly (note the wire color and destination) and
unscrew the two (2) fasteners.