CODE
XXX
CODE
XXX
STEP 3
STEP 6
STEP 9
G
et Ready
A
pply S
ensor
P
repar
e S
ensor A
pplic
at
or
Wash site using a plain soap, dry,
and then clean with an alcohol wipe.
Allow site to air dry before
proceeding.
Peel lid completely off Sensor Pack.
Unscrew cap from Sensor Applicator.
CAUTION:
Sensor codes must
match on Sensor Pack and
Sensor Applicator.
Select site on back of upper arm.
Note:
Avoid scars, moles, stretch
marks, lumps and insulin injection
sites. To prevent skin irritation, rotate
sites between applications. Consider
your comfort and activities.
Refer to your User’s Manual for full System instructions and information.
Touchscreen
Home Button
USB Port
Sensor
Pack
Reader
Place Sensor Applicator over site
and push down firmly to apply
Sensor.
CAUTION:
Do not push down on
Sensor Applicator until placed
over prepared site to prevent
unintended results or injury.
Make sure Sensor is secure.
Discard the used Sensor Pack
and Sensor Applicator. See
Disposal
section in the User’s
Manual.
Gently pull Sensor Applicator
away from your body.
Quick Start Guide
STEP 1
STEP 4
STEP 7
STEP 2
STEP 5
STEP 8
Line up dark mark on Sensor
Applicator with dark mark on
Sensor Pack. On a hard surface,
press down firmly on Sensor
Applicator until it comes to a stop.
Sensor Applicator is ready to
apply Sensor.
CAUTION:
Sensor Applicator
now contains a needle. Do not
touch inside Sensor Applicator
or put it back into Sensor Pack.
Lift Sensor Applicator out of
Sensor Pack.
Lid
Cap
Sensor
Sensor
Applicator
Codes on labels
must match
●
1
Assemble and Apply Sensor
to your body
●
2
Start new Sensor with Reader
●
3
Check your glucose whenever you
want for up to 14 days
Wait 60 minutes
for start-up
Setup Overview
●
1
Assemble and Apply Sensor to your body
FLASH GLUCOSE MONITORING SYSTEM
