5-36
CELL-DYN
®
3200 System Operator’s Manual
9140181H—October 2001
Operating Instructions
Set Up Instructions
Section 5
4. Press
[SELECT PARAMETER]
. The selected parameter is highlighted and the
cursor moves to the first position in the group.
NOTE:
The key label changes to
[PLACE PARAMETER]
and a
[CANCEL
SELECTION]
key is displayed.
5. If necessary, use the Arrow keys on the keyboard to move the cursor to the
desired location and press
[PLACE PARAMETER]
.
NOTE:
When the
[PLACE PARAMETER]
key is pressed, the selected
parameter is displayed in the position indicated by the cursor, the
cursor advances to the next parameter in the list under the printout
group, and the key label changes back to
[SELECT PARAMETER]
.
6. Repeat steps 3–5 until all entries have been made.
7. If desired, press the Print Screen key on the keyboard to obtain a printout of
the configuration.
8. Press
[RETURN]
to return to the
QC SET UP
menu
screen.
9. Repeat this procedure to customize the printout for other QC logs.
Figure 5.16 Operation Set Up Menu Screen
Feb 23, 2001
