CELL-DYN
3000 System Operator’s Manual
12-3
9140240E — May 1995
Chapter 12
Sample Loader
Bar Code Label Placement
All labels should be placed on the tubes securely and without flaps or
edges sticking out. Labels should not cover the cap (high collar) or the
bottom (tail) of the tube. (See Figure 12.3.) Excessive numbers of labels
may prevent tubes from mixing properly.
Figure 12.3:
Tube Labeling Requirements
The bar code label should be placed on the tube just below the stopper
with the bars perpendicular to the length of the tube. See Figure 12.3 for
proper placement.
NOTE: Refer to
information on bar codes and specifications.
Properly Labeled Tubes
Improperly Labeled Tubes
Top Surface
Should Be Dry
16.5 mm
Width Limit For
Multiple Labels
Diameter
Clear
Tape
Barcode
Label
Exposed
Bottom
High
Collar
Tail
Flap
Edges
Peeled
Loose
Search
Go Back
Book TOC