ABB | SACE Tmax XT
126 | © 2020 ABB | 1SDH001821A1002 - ECN000135670
Ekip Touch - Settings | 1 - Main settings
Ekip Touch - Settings
1 - Main settings
Foreword
All the following parameters are available either directly, or from the
Settings
menu, in the conditions
established by Ekip Touch on the basis of the version and configuration described.
To correctly address parameters which are present in the menu but not described below:
• Circuit-breaker: Hardware Trip, T Protection, Neutral Protection
• Phase Sequence
• Monitor time
• Network Analyzer
• Datalogger
• Dual Set
• Functions
please consult the
Settings
menu overview (page 37).
WARNING! changes to the settings must be made in the absence of protection alarms
Bluetooth Low Energy -
Connection security
The Bluetooth antenna on the Trip unit can be activated in the
Bluetooth Low Energy
menu. This is useful
for launching a communication with an external device (tablet, smartphone) according to the Bluetooth Low
Energy protocol, via the
EPiC
APP (page 14).
Activation of Bluetooth Low Energy communication requires the Trip unit to be pre-engineered for a wireless
connection: security of the data and Bluetooth Low Energy connection between the Trip unit and its device is
guaranteed thanks to the
ABB EPiC
application and the pairing configuration described in the next paragraph.
WARNING! It is the customer's sole responsibility to provide and continuously ensure
a secure connection between his device and the Trip unit. The plant manager
must establish and maintain appropriate measures (such as but not limited to the
installation of malware prevention systems, application of authentication measures,
his own system and interface against any kind of security breach, unauthorized
access, interference, intrusion, loss and/or theft of data or information. ABB and its
affiliates are not liable for damages and/or losses related to such security breaches,
unauthorized accesses, interference, intrusion, loss and/or theft of data or information,
use of APPs other than those allowed.
ABB recommends a few general configurations to strengthen the access of data into the Trip unit:
• activate the access PIN code in the Trip unit configure it with a value differing from the default value
• if parameters need not be written, configure the Trip unit only for parameter readout via bus (
Test bus
parameter =
Off
)
• switch off the Bluetooth Low Energy antenna (
Bluetooth Low Energy-Enable
parameter=
Off
) after use
IMPORTANT: communications via wireless and via service connector function
alternatively: if Bluetooth Low Energy is activated there can be no communication
with other accessories via the service connector
