62
TZIDC-210, TZIDC-220
DIGITAL POSITIONER | OI/TZIDC-210/TZIDC-220-EN REV. G
… 11 Diagnosis / error messages
Message codes
Message codes
Message description
Action stopped by operator.
Error during plausibility check.
Action completed, acknowledgment required.
Memory error, data could not be saved.
Safe position is active, action cannot be executed.
Safe position required, but not active.
Valve range limits have not yet been determined; therefore, partial Autoadjust cannot be run.
Data is saved in the non-volatile memory.
Measuring range is exceeded, Auto Adjust was automatically stopped.
Data (factory settings) are being loaded.
Less than 10 % of the measuring range is used.
Action running.
Simulation has been started externally from a PC via HART® protocol; switch outputs, alarm output and analog position feedback are
no longer influenced by the process.
Actual spring action is different from the adjusted one.
Time-out; parameter could not be determined within two minutes; Autoadjust was automatically stopped.
Summary of Contents for TZIDC-210
Page 31: ...TZIDC 210 TZIDC 220 DIGITAL POSITIONER OI TZIDC 210 TZIDC 220 EN REV G 31 Page 2 of 5 ...
Page 33: ...TZIDC 210 TZIDC 220 DIGITAL POSITIONER OI TZIDC 210 TZIDC 220 EN REV G 33 Page 4 of 5 ...
Page 66: ...66 TZIDC 210 TZIDC 220 DIGITAL POSITIONER OI TZIDC 210 TZIDC 220 EN REV G Notes ...
Page 67: ...TZIDC 210 TZIDC 220 DIGITAL POSITIONER OI TZIDC 210 TZIDC 220 EN REV G 67 Notes ...
