![background image](http://html.mh-extra.com/html/abb/srea-01/srea-01_user-manual_219005.webp)
Safety instructions
5
Safety instructions
Overview
This chapter states the general safety instructions that must be followed when
installing and operating the SREA-01 Ethernet Adapter module.
The material in this chapter must be studied before attempting any work on, or with,
the unit. In addition to the safety instructions given below, read the complete safety
instructions of the specific drive you are working on.
General safety instructions
WARNING!
All electrical installation and maintenance work on the drive should be
carried out by qualified electricians.
The drive and adjoining equipment must be properly earthed. Do not attempt any
work on a powered drive. After switching off the mains, always allow the
intermediate circuit capacitors to discharge for 5 minutes before working on the
frequency converter, the motor or the motor cable. It is good practice to check (with a
voltage indicating instrument) that the drive is in fact discharged before beginning
work.
The motor cable terminals of the drive are at a dangerously high voltage when mains
power is applied, regardless of motor operation.
There can be dangerous voltages inside the drive from external control circuits even
when the drive mains power is shut off. Exercise appropriate care when working on
the unit. Neglecting these instructions can cause physical injury or death.
Summary of Contents for SREA-01
