Mechanical installation
23
Mechanical installation
Mounting
1. Choose the location for the module. Note the following:
• The cabling instructions in chapter
must be followed.
• The ambient conditions should be taken into account (see chapter
). The degree of protection of the module is IP20.
2. Switch off all dangerous voltages in the enclosure that the module is to be
mounted in.
3. Fasten the rail.
4. Push the module onto the rail as shown in figure A above. The module can be
released by pulling the locking spring with a screwdriver (see figure B above).
A – Snap on
B – Snap off
Summary of Contents for SREA-01
