ABB SACE Tmax XT5, Operation And Maintenance Manual

Page: 36 / 205

ABB | SACE Tmax XT
34 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A Interface and menus | 4 - Menu
Installation menu
If Ekip Touch detects that
Rating Plug
or
Ekip Measuring
have not been installed properly, it signals an alarm
(page 19) and completes Settings menu with the specific installation section:
Menu Submenus 1 Submenus 2 Commands
Circuit Breaker Installation
Rating Plug Install
Ekip Measuring Install
Correct installation is confirmed by a message on the display and disappearance of the alarm signal and
installation menu.
NOTE: availability of submenus depends on the module, which appears to have not been
installed
Test Menu
Menu Submenus
Description, parameters
and Commands
Page
Autotest - Autotest command 120
Trip Test
- TRIP command 120
Test CB - Close CB , Open CB 120
Ekip CI - Autotest command 121
Ekip Signalling 2K
(1)
Ekip Signalling 2K-1
(1)
Module autotest command 121 Ekip Signalling 2K-2
(1)
Ekip Signalling 2K-3 (1)
ZoneSelectivity
(2)
S Protection
Input , Force Output , Release Output 121
G Protection
(1)
available if one or more Ekip Signalling 2K modules are connected and detected by Ekip Touch
(2)
available if Ekip Touch is on with auxiliary supply
(3)
available with S and/or S2 protection enabled and curve t=k
(4)
available with G and/or Gext protection enabled and curve t=k
About Menu
Menu Submenus Information provided
Protection Unit
-
Information about Ekip Touch: Mainboard serial
number, Trip unit serial number, type, version,
standard, SW version, date and time, language
Circuit Breaker -
CB information: TAG name, CB name, rated current,
number of poles, CB status and position, total
operations, CB serial number
IEC61557-12
(1)
-
Status of 1% measurements (from Class 1 Power
& Energy Metering package), serial number of
assembly and current sensors connected
Feature Collection - List of tripped protections in Trip unit
Modules Modul x
(2)
Module information: serial number, SW version,
status of inputs/outputs/contacts (if present)
Power Controller
(3)
Load Input Status Status of loads (open/closed)
Load Active Load configuration (activated/not activated)
Load shedding
(3)
Load Input Status
Status of loads (open/closed)
Load Active Load configuration (activated/not activated)
(1)
available if Class 1 Power & Energy Metering SW package is provided for by Trip unit module or if it has been
previously activated
(2)
available if one or more modules are connected and detected by unit
(3)
available if function has been installed and enabled in Trip unit