ABB SACE Tmax XT2, User Manual

Page: 97 / 207

1SDH002031A1002 ECN000092998 Rev. B SACE Tmax XT2
– XT4 | 97
Events Ekip Touch can log the last 200 events, mainly related to changes in status and operation of the
unit, specifically:

Status of the bus configuration, operating mode, active setting, auxiliary power supply

States or connection alarms: Current sensors , Trip Coil

Protections: timing in progress or alarm

Trip: status of the opening command, trip signal
NOTE: in the log the first entry is the most recent. Once the 200-event threshold is
exceeded, the oldest ones are progressively overwritten
The complete list is available in the Measurements - Log - Events menu, where each event is
accompanied by a series of information: icon representing the type of event, event name, and
event date and time.
There are four icons that identify the type of event:
Icon Description
Event reported for informational purposes
Timing of a protection in progress, trip pending
Alarm referring to a non-dangerous condition
Operating alarm, malfunction, or connection error
Openings
Ekip Touch is able to log the last 30 TRIPs.
The complete list is available in the Measurements - Log - Openings menu, where each trip
includes the following useful information:

The protection that triggered the opening

The progressive count of the opening

The date and time of the opening (referring to the internal clock)

The measurements associated with the protection that was triggered
NOTE: if the 30-TRIP threshold is exceeded, the oldest events are progressively
overwritten
Related measurements
The protection that trips determines the measurements recorded at the time of opening:
Protection
Measurements
recorded
Remarks
Power
Currents L1, L2, L3,
Ne, Ig Ne is available with CB 4P and 3P + N
Ig is available in the event of trips for G protection
Temperature Currents L1, L2, L3, Ne The temperature cannot be seen on the display