![background image](http://html.mh-extra.com/html/abb/reta-01/reta-01_user-manual_209020.webp)
Quick start-up guide
20
• The detailed procedure of activating the drive for
communication with the module is dependent on the drive type.
Normally, a parameter must be adjusted to activate the
communication. Refer to the
Firmware Manual
of the drive for
information on the communication settings. With an ACS550
drive, set parameter 98.02 COMM PROT SEL to EXT FBA.
With an ACS800, set parameter 98.02 COMM. MODULE LINK
to FIELDBUS and parameter 98.07 COMM PROFILE to ABB
DRIVES or GENERIC according to the selected communication
protocol and profile.
• If the configuration is correct, parameter group 51 should
appear in the parameter list of the drive and show the status of
the RETA-01 configuration parameters.
Network configuration
To enable communication through the Ethernet network, the
module needs a valid IP address. There are numerous ways of
setting the module IP address; see chapter
• One way of setting the IP address is to use the ARP (Address
Resolution Protocol) command from a PC. The new IP address
will be stored in the RETA-01 configuration parameters. An
example of how to change the IP address from the DOS Prompt
window is shown below. In the example, the IP address is
192.100.100.1, and the MAC ID is 00-30-11-FF-00-53 (MAC ID
is printed on a sticker on the housing of the module).
arp -s <192.100.100.1> <00-30-11-FF-00-53>
ping <192.100.100.1>
arp -d <192.100.100.1>
If the connection is established, the module answers:
Reply from 192.100.100.1: bytes=32 time=1ms
TTL=28
...
If the connection is not established the DOS prompts:
Request timed out.
Request timed out.
...
Summary of Contents for RETA-01
