ABB ret650, Technical Manual

Page: 394 / 670

Function block
SRMEMORY
SET
RESET OUT
NOUT
IEC09000293-1-en.vsd
IEC09000293 V1 EN
Figure 176: SRMEMORY function block
Signals
Table 302: SRMEMORY Input signals
Name Type Default Description
SET BOOLEAN 0 Input signal to set
RESET BOOLEAN 0 Input signal to reset
Table 303: SRMEMORY Output signals
Name Type Description
OUT BOOLEAN Output signal
NOUT BOOLEAN Inverted output signal
Settings
Table 304: SRMEMORY Group settings (basic)
Name Values (Range) Unit Step Default Description
Memory Off
On
- - On Operating mode of the memory function
13.3.1.11 Reset-set with memory function block RSMEMORY
Identification
Function description IEC 61850
identification
IEC 60617
identification
ANSI/IEEE C37.2
device number
Reset-set with memory function block RSMEMORY - -
Functionality
The Reset-set with memory function block (RSMEMORY) is a flip-flop with memory
that can reset or set an output from two inputs respectively. Each RSMEMORY
function block has two outputs, where one is inverted. The memory setting controls if
the flip-flop after a power interruption will return the state it had before or if it will be
reset. For a Reset-Set flip-flop, RESET input has higher priority over SET input.
Section 13
1MRK 504 135-UEN A
Logic
388
Technical manual